P0A64
Drive Motor A Phase W Current Low
P0A64 means phase W of drive motor A shows too little current at the moment it should peak, typically an open W lead or a W sensor stuck at zero. GM completes its three-phase sequence with this code on the 2016 Chevrolet Volt motor control processor and in the 2018 hybrid tables: when the rotor sits within 30 degrees of the W phase axis, the inverter runs normal PWM above 50 V and the squared current command exceeds 900 A2 (2016) or 4,900 A2 (2018), a W peak below 9 A for 0.4 s of a 0.6 s window sets P0A64 as Type A, MIL on the first trip. Because the rotor passes each axis in turn, only the open phase is flagged. A Caterpillar patent uses a near-zero phase reading the same way. P0A65 is the high side, P0A5E and P0A61 cover U and V.
Possible causes
- Open circuit in the phase W cable, connector or terminal high
- Phase W current sensor reads zero medium
- Phase W switch of the inverter not conducting medium
- Open winding of phase W in drive motor A low
Symptoms
- MIL and propulsion system warning
- Uneven or reduced electric drive torque
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A64
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.