P0A61
Drive Motor A Phase V Current Low
P0A61 indicates that phase V of drive motor A carries, or reports, too little current when it should be near its peak, pointing to an open phase V circuit. GM uses the same peak-axis test as for phase U on the 2016 Chevrolet Volt motor control processor and in its 2018 hybrid tables, here with the rotor within 30 degrees of the V phase axis: inverter above 50 V in normal PWM, squared current command above 900 A2 in 2016 and 4,900 A2 from 2018, a peak phase current under 9 A for 0.4 s within 0.6 s, Type A with MIL on the first trip. On inverters that sense only two phases a dead V sensor also corrupts the calculated third phase. A Caterpillar patent detects such a sensor by a near-zero phase reading. P0A62 is the high side, P0A5E and P0A64 cover U and W.
Possible causes
- Open circuit in the phase V cable, connector or terminal high
- Phase V current sensor reads zero medium
- Phase V switch of the inverter not conducting medium
- Open winding of phase V in drive motor A low
Symptoms
- MIL and propulsion system warning
- Jerky or weak electric drive
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A61
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.