P0A57
Drive Motor B Current Sensor Circuit Low
P0A57 is set when the signal of the drive motor B current sensor stays below its valid range, usually from a signal line shorted to ground, a missing sensor supply or a failed Hall element. No manufacturer documents P0A57 publicly. A Toyota patent explains the risk of this failure: a sensor held in its ground-short range reports much less current than really flows, the current controller raises its output and can drive the inverter into overcurrent; the system described therefore opens the system relays and warns the driver once the condition repeats. CARB requires out-of-range checks for hybrid input components. P0A58 is the high side, P0A55 the general circuit code, P0A56 plausibility, P0A53 the same check on motor A. Motor B is shut down.
Possible causes
- Sensor signal line shorted to ground high
- Sensor supply voltage missing medium
- Hall element of the current sensor failed medium
Symptoms
- Hybrid warning and MIL
- Drive motor B or the whole high-voltage system switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A57
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.