P0A55
Drive Motor B Current Sensor Circuit
P0A55 is the general circuit fault of the current sensor that measures the current of drive motor B, typically the second traction motor, for example on a rear axle. The inverter needs this signal for torque control and to protect its power switches. No manufacturer documents P0A55 publicly. A Toyota patent shows the principle behind such checks: a control sensor and a monitoring sensor watch the same motor current, and a sensor stuck in its ground-short range or a lasting gap between the two leads to the relays opening. CARB requires circuit checks of hybrid input components. P0A56 is plausibility, P0A57/P0A58 low and high; P0A51 is the same fault on motor A. Usually drive motor B is switched off and the car drives on reduced power.
Possible causes
- Current sensor of drive motor B failed (usually inside the inverter) high
- Sensor supply or signal line interrupted or shorted medium
- Evaluation circuit on the motor B control board faulty low
Symptoms
- Hybrid or electric drive warning with MIL
- Drive motor B disabled, loss of electric all-wheel drive or reduced power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A55
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.