P0A51
Drive Motor A Current Sensor Circuit
P0A51 reports a fault in the circuit of the current sensor that measures the phase current of drive motor A. The inverter needs this value for torque control and overcurrent protection. No manufacturer documents P0A51 publicly with its criteria. A Toyota patent shows the principle: a control sensor and a monitoring sensor measure the same motor current, and if the control sensor sits in its ground-short range or the two differ beyond a threshold over several cycles, the system flags the sensor and opens the main relays, because a wrong reading could drive the inverter into overcurrent. CARB requires circuit checks of hybrid input components. P0A52 covers plausibility, P0A53/P0A54 low and high; P0A55 is motor B. The hybrid system usually shuts down drive motor A.
Possible causes
- Current sensor in the inverter assembly failed high
- Sensor supply or signal line interrupted inside the inverter medium
- Evaluation circuit on the motor control board faulty low
Symptoms
- Hybrid system warning and MIL
- Drive motor A disabled, vehicle may not move or runs on engine only
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A51
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.