P0A4E
Generator Position Sensor Circuit High
P0A4E is set when a generator resolver signal sits above its permitted range, which usually points to an open signal line pulled up by the input circuit or a short to a supply voltage. No manufacturer documents P0A4E publicly. Mitsubishi evaluates the same condition on the 2023 Outlander PHEV but reports it under its own codes: a sine or cosine voltage of 4.9 V or more for 0.21 s stores P0C67 or P0C6C. A Bosch patent explains how the averaged offset of the receiver coil lines reveals whether a line is shorted to supply rather than to ground. CARB requires out-of-range checks for hybrid input components. P0A4D is the low counterpart, P0A4B the general circuit code, P0A4C the plausibility check. The generator is usually shut off and the hybrid warning comes on.
Possible causes
- Open resolver signal line or pushed-out terminal high
- Signal line shorted to a supply voltage medium
- Faulty resolver input stage in the power drive unit low
Symptoms
- Hybrid system warning and MIL
- Generator disabled, engine-only or no-start condition
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A4E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.