P0A4D
Generator Position Sensor Circuit Low
P0A4D reports a generator resolver signal stuck below its permitted range, as caused by a sine, cosine or excitation line shorted to ground or a winding short. No manufacturer documents this code publicly. Mitsubishi shows how the fault is judged but files it under its own codes: on the 2023 Outlander PHEV a sine or cosine voltage at or below 2.0 V for 0.21 s sets P0C66 or P0C6B instead of P0A4D. A Bosch patent describes distinguishing a short to ground from a short to supply by the offset of the receiver coil lines, which is the basis for low/high splitting. CARB requires such circuit checks for hybrid input components. P0A4E is the high side, P0A4B the general circuit fault, P0A4C plausibility. The hybrid system typically shuts the generator down and warns the driver.
Possible causes
- Sine, cosine or excitation line shorted to ground high
- Moisture or corrosion in the resolver connector medium
- Shorted resolver winding inside the generator low
Symptoms
- Hybrid system warning and MIL
- Generator disabled, engine-only or no-start condition
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A4D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.