OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A42

Drive Motor A Position Sensor Circuit High

P0A42 is the counterpart to P0A41: a resolver line of motor A reads above its allowed range. Typical triggers are a sine, cosine or excitation wire shorted to a supply voltage, or an open coil whose line is pulled up by the bias resistors of the input circuit, which drives the converter into clipping. Kia covers it in the same Optima Hybrid 2011-13 bulletin as P0A41: intermittent MIL or hybrid service lamp, fixed by inspecting the HPCU-to-motor sub-harness for internal shorts and pin fit. Bosch patents explain why clipping alone is not enough and how the line offset reveals a short to supply or an open line. P0A3F is the general circuit fault. Expect a warning lamp and reduced or no electric drive.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 42

Possible causes

  • Resolver wire shorted to a supply voltage inside the sub-harness (Kia Optima Hybrid) high
  • Open sine or cosine line pulled high by the input circuit medium
  • Poor pin fit or corrosion at the resolver connectors medium
  • Faulty resolver input stage in the motor control unit low

Symptoms

  • Intermittent MIL or hybrid service lamp
  • Electric drive disabled or vehicle not ready
  • Reduced power until the fault clears

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0A42

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication