P0A3B
Generator A Over Temperature
P0A3B reports that the hybrid generator itself has become too hot, with the temperature sensor working correctly. Mitsubishi documents it as generator coil temperature high on the 2023 Outlander PHEV: the monitor runs continuously and sets the code when the W-phase coil temperature criterion of 199 °C is met for one second. Mitsubishi's checks cover higher-priority codes, the radiator fan, and the EV oil cooling circuit that cools the generator; if those are fine, the generator is replaced. P0A37 to P0A39 are the sensor faults that must be ruled out first, P0A3E the over-temperature of the generator inverter. No other manufacturer documents P0A3B publicly. The system restricts generator output, which can cut charging and series-mode power.
Possible causes
- Fault in the oil cooling circuit of the generator (low oil, leak, pump) high
- Radiator fan not working medium
- Internal generator fault such as damaged winding insulation medium
- Power drive unit commanding excessive generator current low
Symptoms
- Hybrid system warning or overheat message
- Reduced charging and power when the engine drives the generator
- Battery state of charge drops during driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A3B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.