P0A3A
Generator Temperature Sensor Circuit Intermittent
P0A3A flags a generator temperature signal that is interrupted or jumps only briefly. Since the thermal mass of a generator winding rules out sudden steps, such behaviour indicates a contact or wiring problem rather than a real temperature change. No manufacturer documents P0A3A publicly; Mitsubishi (2023 Outlander PHEV) only lists the permanent faults P0A38 and P0A39 for its generator coil sensor, each needing at least 0.5 s outside the valid voltage before it sets, so short dropouts would not trigger them. CARB 1968.2 calls for circuit monitoring of emission-relevant hybrid parts. Symptoms come and go, often with heat, vibration or moisture, and generator use may be restricted while the fault is present.
Possible causes
- Loose or fretting terminal in the generator sensor connector high
- Moisture or corrosion in the connector medium
- Harness chafed against the transaxle housing medium
Symptoms
- Hybrid warning that appears now and then
- Generator temperature jumps in live data
- Occasionally restricted battery charging by the engine
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A3A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.