OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A35

Drive Motor B Over Temperature

Unlike the sensor codes, P0A35 reports that motor B is actually too hot according to a working sensor. GM's 2011 hybrid tables set it above 149 °C (Type A, one trip); the 2013 two-mode trucks use 200 °C, clear it only below 135 °C and run it only while P0A31 is not active (Type B). Mitsubishi sets it on the rear motor of the 2023 Outlander PHEV when the coil reaches 177 °C for one second and names the motor assembly, electric water pump, EV cooling circuit and radiator fan as suspects. Sustained heavy load, towing or a cooling fault are the usual triggers. P0A2F is the same check for motor A, P0A3D for the motor B inverter. The system cuts motor B torque until it has cooled down.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 35

Possible causes

  • Electric coolant pump of the drive cooling circuit failed or weak high
  • Low coolant or transmission fluid in the motor cooling path medium
  • Radiator fan not running or radiator blocked medium
  • Extended high load such as towing or long climbs low

Symptoms

  • Noticeable loss of electric drive power
  • Hybrid system overheat or warning message
  • Engine runs more often to compensate

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0A35

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication