P0A34
Drive Motor B Temperature Sensor Circuit Intermittent
P0A34 covers a motor B temperature signal that drops out or jumps for short moments instead of failing permanently. A winding temperature cannot change by tens of degrees within milliseconds, so such steps point to a loose contact, a chafed wire or a cracked solder joint. No manufacturer documents P0A34 publicly; GM and Mitsubishi only list the permanent faults P0A32 and P0A33 for this sensor, with debounce times of a few hundred milliseconds to seconds that a brief dropout may not meet. CARB 1968.2 requires circuit monitoring of emission-relevant hybrid components. The fault often comes and goes with vibration or heat, and the hybrid system may limit electric drive while it is active.
Possible causes
- Loose or fretting terminal in the sensor connector high
- Wire insulation chafed through at a moving harness section medium
- Cracked joint at the thermistor leads inside the motor low
Symptoms
- Hybrid warning that appears and clears on its own
- Motor B temperature jumps in live data
- Occasional loss of electric drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A34
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.