P0A33
Drive Motor B Temperature Sensor Circuit High
P0A33 is stored when the motor B temperature signal stays above its valid voltage range. With GM's NTC thermistor a voltage near 5 V reads as an impossibly cold motor: GM sets it below -41 °C in the 2011 tables (Type A) and below -40 °C on the 2013 two-mode trucks (Type B, two trips). Mitsubishi flags the rear motor of the 2023 Outlander PHEV when the voltage reaches 4.761 V or more for 0.5 s. That pattern points to an open sensor circuit, an unplugged connector or a short to a voltage source. P0A32 is the low-side fault, P0A31 the rationality check, P0A35 the over-temperature code. Because winding temperature is unknown, the system limits electric drive power and shows a warning.
Possible causes
- Open sensor circuit or unplugged connector high
- Spread or corroded terminals at the motor or module connector medium
- Thermistor open inside the motor medium
- Signal wire shorted to a voltage source low
Symptoms
- Hybrid warning or check engine light
- Motor B temperature shows about -40 °C regardless of conditions
- Electric drive power limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A33
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.