P0A32
Drive Motor B Temperature Sensor Circuit Low
P0A32 means the motor B temperature signal sits below its valid voltage range. GM uses an NTC thermistor, so a voltage near 0 V reads as an impossibly hot winding: the 2011 hybrid tables set it above 184 °C (Type A, one trip), the 2013 two-mode trucks above 230 °C (Type B, two trips). Mitsubishi sets it on the rear motor of the 2023 Outlander PHEV when the sensor voltage is 0.065 V or less for 0.5 s. A signal wire shorted to ground or a shorted thermistor is the typical cause. P0A33 is the opposite fault, P0A31 the plausibility check, and P0A35 a real over-temperature that GM only evaluates while no out-of-range fault is active. The system derates electric drive and warns the driver.
Possible causes
- Sensor signal wire shorted to ground high
- Thermistor shorted inside the motor medium
- Chafed harness between drive unit and motor control module medium
- Faulty sensor input in the motor control module low
Symptoms
- Hybrid warning or check engine light
- Motor B temperature shows an extremely high fixed value
- Electric drive reduced or switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A32
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.