OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A2F

Drive Motor A Over Temperature

Unlike its siblings, P0A2F reports a real thermal problem: the sensor works, but motor A stays too hot. GM sets it on 2013 two-mode trucks when the temperature exceeds 200 °C and does not fall below the 135 °C reset level, Type B, provided no circuit or plausibility fault is active. The 2011 table uses 159 °C; on the 2013 MGU mild hybrid the limit is 165 °C, and torque is already cut linearly from 100 % to zero between 155 and 165 °C. Hyundai lists the code in its Sonata Hybrid sensor bulletin, so a skewed sensor can mimic it. McLaren handles over-temperature under P0A2B98 and points to the dielectric cooling circuit. Expect a warning and sharply reduced electric power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 2F

Possible causes

  • Motor cooling failure such as a weak pump, low fluid or blocked cooler high
  • Sustained high load such as towing or long climbs in electric mode medium
  • Temperature sensor reading too high while still within range low

Symptoms

  • Hybrid system or check engine warning
  • Electric drive power drops sharply or is cut
  • Engine runs more often to support the drive

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0A2F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication