OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A2D

Drive Motor A Temperature Sensor A Circuit High

With an NTC thermistor, a high signal voltage stands for a cold motor, and a voltage close to the 5 V pull-up means the circuit is open. GM sets P0A2D on its 2013 two-mode trucks when the reading falls below -40 °C, Type B over two trips; if the fault is already present at start-up it waits until the motor has warmed up under load for at least 1.5 minutes. The 2011 table uses -41 °C, the 2013 MGU mild hybrid -48 °C with torque above 10 Nm. Typical causes are a broken signal or ground wire, an unplugged connector or an open sensor. Hyundai checks the sensor resistance at the transaxle connector. P0A2C is the low-voltage counterpart. Motor protection is lost, so electric power is limited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 2D

Possible causes

  • Open signal or ground wire of the motor temperature sensor high
  • Connector unplugged or terminal pushed out, often after drive unit work medium
  • Thermistor open inside the motor or transaxle medium
  • Signal wire shorted to a supply voltage low

Symptoms

  • Hybrid system warning or check engine light
  • Motor temperature shows about -40 degrees in live data
  • Electric drive power limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0A2D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication