OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A2C

Drive Motor A Temperature Sensor A Circuit Low

The motor A sensor is an NTC thermistor, so its signal voltage falls as the winding heats; Hyundai's Sonata Hybrid bulletin gives about 11 to 13 kOhm at 20 °C for 2014-15 units. P0A2C means the voltage is too low, which the module reads as an impossibly hot motor: GM sets it on 2013 two-mode trucks above 230 °C (near 0 V), Type B, two trips; the 2011 table uses 184 °C, the 2013 MGU mild hybrid 236 °C. The usual cause is a signal wire shorted to ground or a shorted sensor. P0A2D is the opposite fault, P0A2F a real over-temperature that only counts while the sensor is in range. Hyundai reports a stuck 417 °F reading as a circuit fault. The driver sees a warning and derated electric drive.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 2C

Possible causes

  • Sensor signal wire shorted to ground high
  • Thermistor internally shorted (often only with transaxle or motor) medium
  • Chafed extension harness between drive unit and inverter medium
  • Faulty sensor input in the inverter/motor control module low

Symptoms

  • Hybrid system warning or check engine light
  • Motor temperature shows a very high fixed value in live data
  • Electric drive power reduced or disabled

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0A2C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication