P0A2A
Drive Motor A Temperature Sensor A Circuit
A thermistor in the stator of traction motor A reports winding temperature so the inverter can cut torque before the insulation overheats. P0A2A is the general circuit fault; the failure type sits in the extension byte. McLaren uses P0A2A1C on the Artura when a short or broken wire drives the sensor voltage out of range and P0A2A29 for an invalid signal. GM instead splits the electrical faults into P0A2C and P0A2D. Siblings: P0A2B plausibility, P0A2C low signal (hot), P0A2D high signal (cold or open), P0A2E dropouts, P0A2F real overheating; P2DAC is the same fault on a second sensor B. Hyundai shows the sensor sits inside the transaxle. Expect a hybrid warning and reduced electric power.
Possible causes
- Broken or shorted sensor wire between motor and inverter high
- Loose or corroded connector at the drive unit medium
- Thermistor failed inside the motor or transaxle medium
- Faulty sensor input in the inverter/motor control module low
Symptoms
- Hybrid system warning or check engine light
- Reduced electric drive power
- Implausible motor temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0A2A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.