P0A26
Generator Torque Sensor Circuit Intermittent
P0A26 points to short interruptions or jumps in the generator torque sensor signal rather than a constant fault. The control unit counts implausible signal changes or brief out-of-range events and sets the code once a calibrated limit is exceeded. Because the sensor works next to the generator, as in the Honda patent with a sensor in a hollow generator or motor shaft, heat cycles, vibration and inverter noise favour loose contacts and chafed wires. No manufacturer documents P0A26 publicly; CARB requires an approved generator monitor. Permanent faults show as P0A24 or P0A25. Symptoms often appear only on rough roads.
Possible causes
- Loose or fretted terminal in the sensor connector high
- Chafed wiring near the generator housing medium
- Shield or ground damage letting inverter noise in low
Symptoms
- Hybrid warning that comes and goes
- Brief drop in charging or system power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A26
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.