P0A23
Generator Torque Sensor Circuit Range/Performance
The generator torque sensor sends an electrically valid voltage, but the torque it reports does not fit the generator current, speed and engine load the control unit knows. Typical checks compare the measured value with a torque model or look for an offset while the generator is idle. Such a sensor can sit in the hollow generator shaft, as a Honda patent claims, where magnetic noise and ageing shift the reading. No manufacturer documents P0A23 publicly; CARB requires approved monitoring of generator faults. Pure wiring faults appear as P0A22, P0A24 or P0A25. The system tends to cap generator torque.
Possible causes
- Sensor zero point or gain drifted high
- Electromagnetic interference from the generator or inverter medium
- Contact resistance in the connector skewing the signal low
Symptoms
- Hybrid system warning light
- Generator output limited, battery charges slowly
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A23
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.