P0A18
Motor Torque Sensor Circuit Range/Performance
The motor torque sensor delivers an electrically valid signal, but the torque it reports does not match what the control unit expects from the commanded motor current, speed and operating state. Typical checks compare measured and estimated torque or look for an offset when no torque is applied. Honda patents show such a sensor mounted inside the hollow output shaft of a traction motor, where electromagnetic noise is a known accuracy issue. No manufacturer documents P0A18 publicly. CARB requires approved monitoring of drive motor faults that impair propulsion. P0A17 is the plain circuit fault; P0A19 and P0A20 are out of range low and high. The drive system usually limits electric torque.
Possible causes
- Sensor offset or gain drifted, reading off against the torque model high
- Electrical interference on the signal from damaged shielding or ground medium
- Missing or outdated calibration after module or drive unit replacement medium
- Mechanical fault in the drive unit that changes the real torque low
Symptoms
- Hybrid system warning light
- Reduced or uneven electric assistance
- Engine runs more often, fuel use rises
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A18
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.