P0A17
Motor Torque Sensor Circuit
Some electric drive units measure the torque on the motor or generator shaft directly, for example with a magnetostrictive sensor inside a hollow motor shaft as described in Honda patents for hybrid drive systems. The control unit uses that value to check the torque it commands. P0A17 is the general circuit fault of this sensor, set when the signal is missing or cannot be evaluated at all. No manufacturer documents P0A17 publicly. CARB requires a monitoring plan for drive motor faults that affect propulsion or emission strategies, which covers such feedback sensors. Plausibility is P0A18, low and high P0A19 and P0A20, intermittent P0A21. Expect reduced electric power and a hybrid warning.
Possible causes
- Loose or corroded sensor connector at the drive unit high
- Damaged sensor wiring between drive unit and control module medium
- Torque sensor or its excitation electronics failed, often only replaceable with the drive unit medium
- Input stage of the hybrid or motor control module faulty low
Symptoms
- Hybrid system warning light
- Electric drive power limited or electric drive disabled
- Higher fuel consumption because the engine runs more often
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A17
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.