P0A15
Engine Mount A Control Circuit Low
The control circuit of switchable or active engine mount A shows a voltage or current below the expected level, which usually points to a short to ground on the line or inside the actuator. Ford uses P0A15 in its 2020 to 2023 gasoline OBD summary for the active mounts: the low-level driver reports the fault and the PCM matures it after about 5 seconds; the partner mount B has P0AB7. Honda's active control engine mount system on the 2008 Pilot V6 assigns P0A15 to the front mount actuator and P0AB7 to the rear. Ford engineers describe these mounts as switched between a damping and a stiffening mode, so a stuck mount is felt as vibration. The open circuit is P0A14, the high fault P0A16.
Possible causes
- Control wire chafed on the engine or subframe and shorted to ground high
- Shorted coil in the mount actuator or solenoid, often after fluid leakage medium
- Moisture in the mount connector low
Symptoms
- Noticeable vibration at idle or low speed
- Warning light, depending on manufacturer
- Cylinder deactivation may be suppressed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0A15
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.