OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A14

Engine Mount A Control Circuit/Open

Some vehicles use switchable or active engine mounts that the powertrain or a mount control unit changes between soft and firm, or drives with an actuator against vibration. P0A14 reports an open or undefined fault in the control circuit of mount A. Ford lists it in its 2020 to 2023 gasoline OBD summary as the active mount circuit check: the low-side driver reports the fault and it matures after about 5 seconds; mount B uses P0AB6 to P0AB8. Honda's active control engine mounts, for example on the 2008 Pilot V6, use P0A14 for the front mount actuator and P0AB6 for the rear. P0A15 and P0A16 cover low and high faults. The car stays drivable, but vibration may increase.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 14

Possible causes

  • Mount actuator connector loose, corroded or unplugged after engine work high
  • Open coil in the mount actuator or switching solenoid medium
  • Wire broken where the harness flexes with engine movement medium
  • Fault in the engine or mount control unit output low

Symptoms

  • More vibration at idle or during cylinder deactivation
  • Warning light, depending on manufacturer
  • Shudder that feels like a torque converter problem

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0A14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication