P0A13
DC/DC Converter Enable Circuit High
The enable line to the DC/DC converter reads high when the control module expects it low, for example while the converter should be switched off. The usual reasons are a short to battery voltage on the enable wire, a stuck output driver, or a missing pull-down. Since a high enable level normally permits converter output, the converter may keep running when it should not – during shutdown, a fault or high-voltage disconnection – which the module treats as a safety and battery-drain risk. No manufacturer documents P0A13 publicly in an official source; the explanation relies on CARB and on patents describing hard-wired DC/DC enable lines cross-checked against a CAN request. P0A11 is the open line, P0A12 the low fault; status-side faults are P0A08 to P0A10.
Possible causes
- Enable wire shorted to 12 V or another supply high
- Enable output driver in the control module stuck on medium
- Open pull-down or ground reference at the converter input low
Symptoms
- Hybrid system or battery warning light on
- 12 V battery drains while the vehicle is parked
- Converter-related functions disabled as a precaution
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0A13
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.