OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A11

DC/DC Converter Enable Circuit/Open

General or open-circuit fault on the enable line with which the hybrid or battery control module tells the DC/DC converter that it may deliver power to the 12 V system. In typical designs a high enable level permits converter output, and a CAN message carries the same permission in parallel, so the two can be cross-checked. If the line is open, the converter cannot be switched on reliably and the 12 V battery is no longer charged. No manufacturer documents P0A11 publicly in an official source; Honda's hybrid recall shows what follows when the converter shuts down: charging warning, discharged 12 V battery, possible loss of drive. Low and high faults on the same line are P0A12 and P0A13; status line faults are P0A08 to P0A10.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 11

Possible causes

  • Broken enable wire or unplugged connector between control module and converter high
  • Corroded or pushed-out terminal at the converter enable pin medium
  • Faulty enable output driver in the control module low
  • Faulty enable input inside the DC/DC converter low

Symptoms

  • Battery or charging warning light on
  • 12 V battery is not charged and runs down
  • Vehicle may lose motive power after a while

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0A11

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication