P0A10
DC/DC Converter Status Circuit High
The status signal from the DC/DC converter to the hybrid control module sits above its valid range, typically because the line is shorted to a voltage source, its ground or pull-down path is open, or the converter drives the output high after an internal failure. The converter supplies the 12 V system from the traction battery, and its self-diagnosis reports problems over this status path. No manufacturer documents P0A10 publicly in an official source; older lists that call it a hybrid battery voltage sense circuit are wrong for today's J2012. Siblings: P0A08 is the general status fault, P0A09 the low signal. A converter that stops working shows up as warning lights and a falling 12 V voltage until the hybrid system shuts down.
Possible causes
- Status line shorted to 12 V or another supply medium
- Open ground or signal return at the converter connector medium
- DC/DC converter internal fault driving the status output high medium
- Faulty input stage in the hybrid control module low
Symptoms
- Hybrid system or battery warning light on
- 12 V battery voltage falls while driving
- Possible shutdown of the hybrid system if the 12 V battery runs flat
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A10
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.