P0A0E
High Voltage System Interlock Circuit A Intermittent
The interlock loop A signal drops out or jumps for short moments and then recovers, so the module sees an unstable loop rather than a lasting open or short. Typical are connectors with loose or spread contacts, harness sections that move with the body or drivetrain, and moisture in seals. No manufacturer documents P0A0E publicly; the GM tables only list P0A0C and P0A0D for the same loop. Reference designs and patents on interlock monitoring describe the loop as a current or voltage path through each HV connector and point out that contact resistance and interference can cause brief false trips. CARB treats the HVIL as a safety-only system. For the driver this means sudden HV shutdowns or no-starts that come and go; static faults use P0A0A to P0A0D.
Possible causes
- Loose or spread interlock contacts in an HV or low-voltage connector high
- Harness section with a broken strand that opens under vibration medium
- Moisture entering through a damaged connector seal medium
- Electrical interference on the interlock line or a weak module input low
Symptoms
- Hybrid/EV warning that appears and disappears
- Occasional loss of ready mode or sudden shutdown of electric drive
- Intermittent no-start, often after rough roads or rain
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A0E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.