OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A0A

High Voltage System Interlock Circuit A

The high-voltage interlock loop (HVIL) is a low-voltage signal loop routed through every HV connector, the service disconnect and component covers. If it opens, the control module opens the main contactors so no one can touch live parts. P0A0A is the general circuit fault on loop A. Stellantis sets P0A0A-00 on the Jeep Wrangler and Grand Cherokee 4xe when an HV connector is torqued but not fully seated after repair, and on the 2024-2025 Pacifica Hybrid it was traced to battery pack control module software; there the car will not start on either power source. Mercedes logs P0A0A00 in the DC converter of model line 243. CARB counts the HVIL as a safety-only system, so MIL behaviour varies. Low, high, performance and intermittent faults use P0A0B to P0A0E.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 0A

Possible causes

  • HV connector or service disconnect not fully seated after repair high
  • Spread, bent or corroded interlock pins or damaged connector seals medium
  • Interlock wiring chafed or cut medium
  • Battery pack control module software fault (Chrysler Pacifica Hybrid 2024-2025) low

Symptoms

  • Vehicle will not start or go into ready mode
  • Check engine and hybrid system warning on
  • High-voltage system switched off while the 12 V system still works

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0A0A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication