P0A09
DC/DC Converter Status Circuit Low
The status signal that the DC/DC converter sends to the hybrid control module stays below its expected range, typically from a short to ground, an open line read as low, or a converter that pulls its status output down because of an internal fault. Mitsubishi uses P0A09 on the 2012-2013 i-MiEV for a DC-DC converter fault; its bulletins tie it to a failed on-board charger that blows the high-voltage fuse feeding the converter, after which the 12 V battery and drive battery stop charging. That usage predates the current split into P0A08, P0A09 and P0A10. Siblings: P0A08 covers the general circuit fault, P0A10 a signal stuck high. Expect warning lights and a 12 V battery that slowly runs flat.
Possible causes
- Blown high-voltage fuse feeding the converter, e.g. after an on-board charger failure (Mitsubishi i-MiEV) high
- DC/DC converter internal fault pulling the status output low medium
- Status line shorted to ground or chafed harness medium
- Faulty input stage in the hybrid/EV control module low
Symptoms
- Power unit, battery or hybrid warning light on
- 12 V battery not charged, voltage drops
- On EVs the drive battery may also stop charging
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A09
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.