P0A08
DC/DC Converter Status Circuit
General fault on the status line through which the DC/DC converter reports its condition to the hybrid control module. The converter replaces the alternator: it steps the traction battery voltage down to charge the 12 V battery. When its self-diagnosis detects an internal problem it signals this back, and the controller reacts. P0A08 is the broad verdict for an unusable or implausible status signal; a signal stuck low or high has its own codes P0A09 and P0A10. No manufacturer documents P0A08 publicly in an official source. Toyota's Prius c recall shows the consequence of a dead converter: warning lights, then a draining 12 V battery that can shut the hybrid system down. Drivers should not keep driving for long.
Possible causes
- Internal fault in the DC/DC converter reported by its self-diagnosis high
- Damaged or corroded status line or connector between converter and hybrid control module medium
- Converter overheating due to a fault in the inverter/converter coolant loop low
- Faulty input stage in the hybrid control module low
Symptoms
- Hybrid system, battery or master warning light on
- 12 V battery is no longer charged and voltage drops while driving
- Electrical consumers fail and the hybrid system may finally shut down
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0A08
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.