P0A07
Motor Electronics Coolant Pump A Control Circuit High
The module measures a voltage on the pump A control line that is higher than the commanded state allows, typically because the line touches a supply wire or the pump input has failed internally. The pump in the inverter and motor cooling loop may then be stuck on or never receive a valid command. No manufacturer documents P0A07 publicly. GM's Volt flags a short to voltage on its equivalent pump line as P0CE9, with 16 failures in 20 samples at 250 ms and a two-trip MIL. CARB requires inverter cooling outputs to be monitored for such circuit faults; Toyota patents describe pump speed and coolant flow checks for the same loop. P0A05 and P0A06 cover open and short to ground.
Possible causes
- Control wire shorted to a battery or ignition supply wire high
- Pump control electronics failed, pulling the input high medium
- Output driver in the control module damaged low
Symptoms
- Hybrid system or check engine light
- Pump running all the time, even with the vehicle off
- Possible power limitation if cooling cannot be confirmed
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0A07
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.