P0A06
Motor Electronics Coolant Pump A Control Circuit Low
The control line of pump A in the drive electronics coolant loop sits at a voltage below what the module expects for the commanded state, usually because the line or the pump input is shorted to ground. Depending on the driver design, the pump then runs uncontrolled or not at all. No manufacturer documents P0A06 publicly; GM's Volt reports a short of the comparable pump control line under P0CE9 (16 of 20 samples at 250 ms, Type B). CARB requires circuit checks of inverter cooling outputs, and Toyota patents show why a failed pump must be separated from radiator or fan faults. P0A05 is the open case, P0A07 the short to voltage. A failing pump soon leads to power reduction.
Possible causes
- Control wire chafed against the body and shorted to ground high
- Internal short at the pump's control input medium
- Water or coolant in the pump connector medium
Symptoms
- Hybrid system or check engine light
- Electronics temperature rising quickly, power limited
- Pump silent when commanded on, or running continuously
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0A06
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.