OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A02

Motor Electronics Coolant Temperature Sensor A Circuit Low

The signal voltage of the coolant temperature sensor in the electronics loop sits below its valid window. Because the sensor is an NTC thermistor, a low voltage means an implausibly hot reading, typically a short to ground. GM uses P0A02 on the 2013 Two-Mode hybrid Tahoe, Yukon, Escalade, Silverado and Sierra: the converted temperature reaches the 162.1 °C limit in 30 of 50 samples taken every 100 ms, after more than 10 s of propulsion active and with no intake air sensor fault (P0112, P0113) present. It is a Type B code with MIL after two trips. The opposite fault is P0A03. Expect a warning light and possibly reduced electric power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 02

Possible causes

  • Signal wire chafed through and shorted to ground high
  • Internal short in the thermistor medium
  • Moisture or coolant in the connector bridging signal to ground medium

Symptoms

  • Check engine or hybrid warning light
  • Displayed electronics temperature extremely high although the system is cool
  • Cooling fans and pump running at full output, drive power limited

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0A02

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication