OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0A01

Motor Electronics Coolant Temperature Sensor A Circuit Range/Performance

The sensor delivers a value inside its electrical range, but it does not fit the other temperatures in the vehicle. GM uses this code on the 2013 Two-Mode hybrid Tahoe, Yukon, Escalade, Silverado and Sierra as a cold-start test: after the vehicle has stood for more than 28,800 s (8 h), the power electronics coolant temperature at power-up may differ from engine coolant temperature by no more than 30 °C, provided engine coolant and intake air agree within 15.75 °C. A failure is a Type B code with MIL after two trips. Nissan describes a similar comparison between inverter coolant and power element temperatures. Hard electrical faults are P0A02 and P0A03.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberA / 01

Possible causes

  • Sensor characteristic drifted, reading offset against the other temperature sensors high
  • Added resistance at a corroded connector shifting the reading medium
  • Low coolant or air pocket at the sensor in the electronics loop medium
  • Fault actually in the engine coolant or intake air sensor used for comparison low

Symptoms

  • Check engine light after two trips
  • Often no noticeable change in driving behaviour
  • Electric drive power limited when the electronics are hot

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0A01

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication