P09A9
Gate Select Position Circuit C High
Logged when the gate select signal on circuit C sits above its highest plausible value for longer than a calibrated time. Usual suspects are a short to the sensor supply or battery voltage, an interrupted sensor ground, or a sensor with an internal fault. No manufacturer publicly documents this code, and the physical meaning of circuit C is not published either. An Aisin AI patent describes the fallback once select feedback is lost: warning, stop request and a limp-home in first gear. CARB requires out-of-range checks on such inputs. P09A8 is the low counterpart, P09A6 the general C fault, P0907 and P09A5 the high faults of A and B. Shifting is usually curtailed.
Possible causes
- Signal wire of circuit C shorted to supply or battery voltage high
- Open or corroded sensor ground medium
- Internal fault of the sensor delivering signal C medium
- Faulty input stage in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Limp-home mode, often in a single low gear
- Gear changes refused while driving
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.