P09A8
Gate Select Position Circuit C Low
The module stores this code when the gate select signal on circuit C remains below its valid range for a calibrated time. Common triggers are a signal wire shorted to ground, a missing sensor supply or an internal sensor fault; depending on the sensor type, a broken signal wire can read low as well. No manufacturer documents this code publicly or explains what circuit C measures. Patents from Isuzu and Aisin AI show the select sensor as the feedback the module needs to line up the right gate. CARB requires out-of-range checks on such inputs. P09A9 is the high counterpart, P09A6 the general C fault, P0906 and P09A4 the low faults of A and B.
Possible causes
- Signal wire of circuit C shorted to ground high
- Sensor supply for circuit C missing or pulled down medium
- Internal short in the sensor delivering signal C medium
- Faulty input stage in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Gearbox holds one gear or drops to neutral
- Transmission warning message in the instrument cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.