P09A7
Gate Select Position Circuit C Range/Performance
Rationality fault on gate select circuit C: the value is electrically valid, yet it disagrees with the other select channels, the learned gate positions or the commanded movement. A Mannesmann Sachs patent shows why several select signals can exist: when one sensor fails, the remaining ones still allow controlled positioning before an emergency mode based on stored drive times takes over. No manufacturer documents this code or the role of circuit C publicly. CARB requires rationality checks on such inputs. P09A6, P09A8 and P09A9 are electrical faults of C, P0905 and P09A3 the same check on A and B. The driver usually notices slower or restricted shifting.
Possible causes
- Drifting or worn sensor so signal C disagrees with the other channels high
- Select positions not relearned after repair work on the actuator or gearbox medium
- Loose sensor mounting or magnet shifting the measured position medium
- Contact resistance in the connector of circuit C low
Symptoms
- Check engine or transmission warning light on
- Slower or hesitant gear changes
- Some gears no longer offered
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.