P09A6
Gate Select Position Circuit C
Electrical fault on a third gate select position signal (circuit C) that fits none of the more specific C codes. Public AMT designs show far fewer channels: Aisin AI and Isuzu use one select sensor, and a Mannesmann Sachs patent combines motor encoders with an extra neutral position sensor. What a third channel is in practice remains open. No manufacturer documents this code publicly. CARB requires circuit checks on such inputs. P09A7 to P09A9 are the plausibility, low and high faults of C; as with circuit B there is no intermittent variant. P0904 and P09A2 cover circuits A and B. Gear changes may be limited.
Possible causes
- Loose, corroded or wet connector at the select sensor or actuator unit high
- Damaged signal wire of circuit C in the gearbox harness medium
- Faulty sensor supplying signal C medium
- Faulty input stage for circuit C in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Delayed or missing gear changes
- Vehicle reluctant to pull away
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.