OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P09A5

Gate Select Position Circuit B High

Indicates that the gate select signal on circuit B has stayed above its highest valid value for longer than allowed. Typical reasons are a short of the signal wire to the sensor supply or battery voltage, an open sensor ground, or a defective sensor. No manufacturer publishes how it uses this code or what circuit B physically is. An Aisin AI patent shows the consequence of losing select feedback: warning, request to stop, then a limp-home in first gear. CARB requires out-of-range checks on such inputs. P09A4 is the low counterpart, P09A2 the general fault, P0907 and P09A9 the high faults of circuits A and C. A gearbox that can no longer confirm its gate restricts shifting.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / A5

Possible causes

  • Signal wire of circuit B shorted to sensor supply or battery voltage high
  • Open sensor ground or corroded ground pin medium
  • Internal fault of the select sensor medium
  • Faulty input stage in the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • Gearbox stays in one gear or in neutral
  • Limp-home mode with very limited gear choice

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P09A5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication