P09A4
Gate Select Position Circuit B Low
Set when the gate select signal on circuit B stays below its lowest valid value for longer than a calibrated time. Likely causes are a signal line shorted to ground, a lost sensor supply or an internal sensor short; with potentiometer sensors like the select position sensor in an Isuzu patent, an open signal wire often reads low too. No manufacturer documents this code publicly, nor whether B is a second track or another sensor. CARB requires out-of-range checks on such inputs. P09A5 is the opposite fault, P09A2 the general circuit fault, P0906 and P09A8 the low faults of circuits A and C. If A and B are both low, look for a shared supply or ground.
Possible causes
- Signal wire of circuit B chafed through and shorted to ground high
- Sensor reference supply interrupted or shorted medium
- Internal short or broken wiper in the select sensor medium
- Faulty input stage in the transmission control module low
Symptoms
- Check engine or transmission warning light on
- Gear changes blocked or limited to a few gears
- Transmission warning message in the instrument cluster
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.