P09A3
Gate Select Position Circuit B Range/Performance
Plausibility fault of gate select circuit B: the signal is electrically valid but does not match what the module expects. That could be the reading of circuit A, the learned gate positions, or the target gate the module has commanded, as in the Aisin AI select control that compares actual and target gate. Which comparison applies depends on whether B is a redundant track or a separate sensor, and no manufacturer publishes that or uses this code in citable material. CARB requires rationality checks on such inputs. P09A2, P09A4 and P09A5 are electrical faults of B, P0905 and P09A7 the same check on circuits A and C. A fallback mode with limited shifting is likely.
Possible causes
- Worn or drifting select sensor, signal B no longer agrees with the reference high
- Gate positions not relearned after actuator, clutch or module replacement medium
- Contact resistance at connector pins distorting signal B medium
- Sluggish or worn select mechanism so the measured gate lags the commanded one low
Symptoms
- Check engine or transmission warning light on
- Wrong gate selected or gears refused
- Slow, jerky shifting in fallback mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P09A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.