OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P09A2

Gate Select Position Circuit B

General electrical fault on the second gate select position signal (circuit B) of an automated manual gearbox. The published designs from Isuzu (one select potentiometer) and Aisin AI (one select stroke sensor) show only a single sensor, so it is not documented whether B is a redundant second track of that sensor or a separate sensor. No manufacturer documents this code publicly. CARB requires circuit checks on such inputs. P09A4 and P09A5 are the more specific low and high faults of circuit B, P09A3 its plausibility fault; unlike circuit A (P0908) there is no intermittent variant. P0904 and P09A6 cover circuits A and C. Expect shifting to be restricted.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / A2

Possible causes

  • Loose, corroded or wet connector at the select sensor or actuator unit high
  • Chafed or broken signal wire of circuit B near the gearbox medium
  • Faulty select sensor, often integrated in the shift and select actuator medium
  • Faulty input stage for circuit B in the transmission control module low

Symptoms

  • Check engine or transmission warning light on
  • Gearbox shifts slowly or locks out certain gears
  • Gearbox stays in one gear or neutral

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P09A2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication