P099D
Shift Solenoid H Control Circuit Range/Performance
Electrical feedback from the drive circuit of shift solenoid H does not fit the command, although no hard short or open is seen. No manufacturer was found to document this code. Solenoid H means an eighth shift solenoid. The only documented H user, the 2017–2018 Genesis G80 and G90, reports its on/off solenoid for the shift-by-wire park function under P076A and P076D, outside this block. Ford's OBD summaries describe shift solenoid checks only up to E, with separate open, short to ground and short to power codes and 0.5 to 5 s electrical monitoring. CARB requires transmission outputs to be checked for proper function. Low and high are P099E/P099F, the open circuit is P09A1.
Possible causes
- Solenoid coil resistance out of specification high
- High-resistance connector or harness contact medium
- Weak driver stage in the transmission control module low
Symptoms
- Warning light depending on calibration
- Harsh or missing shifts involving this solenoid
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P099D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.