P099C
Shift Solenoid G Control Circuit High
High-voltage fault in the control circuit of shift solenoid G. Mitsubishi's 2019 six-speed uses P099C for an open circuit of the low-reverse brake shift solenoid: with the solenoid commanded off and transmission relay voltage of 2 V or more, a reading of 3.7 V or more for 0.5 s sets the code. So on this design an open shows up as high, not under P09A0. The drive cycle needs only 10 s with the ignition on. Causes named are the harness, connectors, the TCM and the solenoid in the valve body. Nissan lists P099C as shift solenoid G for the 2012–2017 Versa, Versa Note and Sentra with the RE0F11A CVT, with control valve replacement as the fix. P099B is the low side, P099A performance.
Possible causes
- Open control wire or connector between module and valve body high
- Open solenoid coil inside the valve body medium
- Control wire shorted to voltage low
Symptoms
- Check engine light
- No reverse or harsh reverse engagement (Mitsubishi)
- Limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P099C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.