P0997
Shift Solenoid F Control Circuit Range/Performance
The drive circuit of shift solenoid F works electrically but its measured current or voltage does not fit the command. No manufacturer was found to document this code. The users of the F block, Nissan's RE0F11A CVT and a 2019 Mitsubishi six-speed, list only P0998 and P0999. FCA's nine-speed bulletin 21-019-17 (2015 Chrysler 200 and Jeep Cherokee) shows how the slot is used for solenoids 2 to 5, with P0975, P0978, P0981 and P0984 for control circuit performance, but stops before a sixth solenoid. Genesis reports an electrical fault of its solenoid F under P2709 instead. CARB requires transmission outputs to be checked for proper function. P097F is the open circuit, P0998/P0999 low and high.
Possible causes
- Solenoid coil resistance out of specification high
- High-resistance connector or harness contact medium
- Weak driver stage in the transmission control module low
Symptoms
- Warning light depending on calibration
- Missing or harsh shifts into gears using this solenoid
- Possible limp mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0997
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.