P0996
Transmission Fluid Pressure Sensor/Switch F Circuit Intermittent
The signal of pressure sensor or switch F drops out or flickers for short moments without staying low or high. No manufacturer documents this code publicly, and no transmission with a sixth pressure switch was found: GM's six-speeds end at switch 5 (E), Mitsubishi's 2019 six-speed uses letters B, D and E. Because such switches are thin film-and-piston units inside the valve body module, as Sonnax shows, debris or a delaminated film can make the contact chatter, and connector or harness faults do the same electrically. CARB requires transmission inputs to be checked for circuit faults; an intermittent code is the slot for faults too short to set P0994 or P0995. Expect occasional rough shifts, often without a warning light.
Possible causes
- Loose or corroded connector contact high
- Debris or delaminated film making the switch chatter medium
- Chafed harness shorting or opening under vibration medium
Symptoms
- Stored fault, often without warning light
- Occasional rough or flared shift
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0996
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.