OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0994

Transmission Fluid Pressure Sensor/Switch F Circuit Low

The signal of pressure sensor or switch F stays low. No manufacturer documents this code publicly. With a normally closed switch as described by Sonnax for GM's valve body modules, low means the contacts stay closed, so the module sees no pressure where pressure should be, or the signal wire is shorted to ground. GM's equivalent for switch E, P0989, flags a low signal when commanded pressure is 50 kPa or less and handles it as Special No Trip without MIL; Saab's 9-4X text gives 0 V as the low state and 12 V as high. For an analogue sensor, low would mean a voltage below its valid range. CARB requires such out-of-range checks on transmission inputs. P0995 is the high counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 94

Possible causes

  • Signal wire shorted to ground high
  • Switch stuck closed by debris or damaged film medium
  • Clutch circuit not reaching pressure (valve or seal leak) low

Symptoms

  • Harsh or delayed shifts
  • Shift adaptation frozen
  • Possible limp mode

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0994

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication