P0993
Transmission Fluid Pressure Sensor/Switch F Circuit Range/Performance
Pressure sensor or switch F is electrically intact, but its reading does not match what the module expects from the commanded clutch state. No manufacturer documents this code publicly. The closest documented logic is GM's for switch E (TFP switch 5, 6T70/6T75): the module checks after each clutch release whether the switch returns to its exhausted state and counts failures, at 50 kPa or less commanded pressure for the low case. A sixth switch would be checked the same way, plausibility against commanded pressure and gear, which CARB requires for transmission inputs. Typical causes are sticking regulator valves, debris and worn switch films rather than wiring. P0992 is the plain circuit fault, P0994/P0995 are low and high.
Possible causes
- Sticking clutch regulator valve feeding the switch high
- Worn or delaminated switch film, debris in the switch medium
- Low or contaminated transmission fluid medium
Symptoms
- Harsh or flared shifts
- Shift adaptation frozen
- Warning light depending on calibration
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0993
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.