OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0992

Transmission Fluid Pressure Sensor/Switch F Circuit

General circuit fault of a sixth transmission pressure sensor or switch, labelled F. No manufacturer documents this code publicly, and no gearbox with a switch F was found. GM's six-speeds stop at TFP switch 5 (letter E, P0989/P0990), and Mitsubishi's 2019 six-speed monitors its 2-6 brake, high clutch and low-reverse brake switches under P0846, P0876 and P0988, which are letters B, D and E. Pressure switches like these sit in the valve body module and tell the module which clutch is applied; Sonnax describes them as normally closed film-and-piston switches. P0992 would be the code for an open or implausible circuit without a low/high split, as CARB requires circuit checks on transmission inputs. Range/performance, low, high and intermittent are P0993 to P0996.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number9 / 92

Possible causes

  • Open or damaged signal wire or connector to the switch high
  • Pressure switch or sensor failed inside the valve body module medium
  • Transmission control module input fault low

Symptoms

  • Warning light depending on manufacturer calibration
  • Harsh or delayed shifts
  • Possible limp mode with a fixed gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0992

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication